Craftsman Garage Door Opener - Won't Open with Remote

dddellingerMay 3, 2008

Here's a good one: my Craftsman garage door opener won't work with any of the remotes. When I press the remote button, I can see the "receive" light on the back of the opener flash, so I know the problem is not in any of the remotes. Any thoughts on how to repair this?

BTW, it works fine with the wired switch.

Thank you for reporting this comment. Undo

Make sure the lock function on the wall control is on. If the light in the wall control is flashing press and hold the lock button for about 3 seconds.

    Bookmark   May 5, 2008 at 10:57AM
Sign Up to comment
More Discussions
Wayne Dalton i-Drive vs. Belt Drive vs. Screw Drive
Hello All, I am looking to install 2 new garage door...
Need error codes for Craftsman 41A4315-7D.
Need error codes for Craftsman 41A4315-7D Garage Door...
Sears GDO does not close
I've searched on the forum without any luck. My Sears...
craftsman 1/2 hp battery key pad ok / remotes &...
2x6 strength? How much weight will a truss in my garage hold?
I want to build an engine hoist in my garage. I found...
Sponsored Products
Pes Paper Knife by Alessi
$31.00 | Lumens
Bali SkyTrack 3/8-inch Double Cell Daybreak II Skylights
Broan-Nutone Hampton 15.75W x 25.5H in. Recessed Medicine Cabinet 625N244 - 625N
$167.99 | Hayneedle
Clifton Black 28-inch to 48-inch Curtain Rod
$53.95 | Bellacor
Tommy Bahama Royal Kahala Sumatra Accent Chair
Lightolier 5" White Recessed Trim with Florentine Medallion
$49.98 | Lamps Plus
Horizontal Rim Lock Set with Porcelain Knobs
Signature Hardware
Kathy White 1-door Linen Tower with Mirror
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™