Garage door opener repair

pittsloanApril 3, 2007

I have a Sears Craftsman garage door opener which is about 10 yrs old. I had to replace the worm and drive gears. All new parts are working, however, when activated the door opener only cycles enough to open the door about 20 inches. Adjustment of Limits and Force do nothing to change the cycle.

Is there some sort of reset on the circuit board that I am missing? Anybody else experience this problem?

Thank you for reporting this comment. Undo
don_1_2006

Sounds like the chain was not reinstalled correctly. Loosen the chain and remove it from the sprocket on top of the motor unit. With the door closed, use the remote and run the motor until that sprocket turns clockwise and stops. Reinstall the chain and give it a try. I hope you remember the settings for the force and limit adjustments.

    Bookmark   April 4, 2007 at 12:48PM
Sign Up to comment
More Discussions
Need help diagnosing Chamberlain Garage Door Problem
Hi, Have a 1/3 Chamberlain Liftmaster that started...
koalb01
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
Snowblower help
I have a M t d model 317e760f118 track driven snow...
thechad1985
Easy to use Backpack Blower Storage
I have been keeping my backpack blower on the floor...
blakeas
Cabinets
Hi friends, I am looking for cabinets for my garage...
davidnc
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™