Replace plastic gears in Craftsman opener

knoopApril 30, 2007

I have an issue with my opener where I can hear the motor but does not move the chain. I opened the cover and found plastic shavings. One of gears was completely gone. I tried to remove the gear, but I am having a hard time removing the roller pins above and below the gear. Is there a trick to removing these gears ow should they come out easily? Thanks in advance for your help

Thank you for reporting this comment. Undo
don_1_2006

You only need to remove the roll pin from the bottom of the gear and it will slide off. If you buy the new gear it should come with instructions.

    Bookmark   April 30, 2007 at 7:48PM
Sign Up to comment
More Discussions
who makes a 10x8 "Carriage House" style garage door?
Perusing the websites of most of the major garage door...
Daniel501
Garage door won't open - even manually
Our garage door won�t open - the motor works,...
karyn
Relocate Carriage House on new foundation?
Hi there. My 1985 Victorian home here in Maine also...
dplayers1
Chamberlain Garage Door Opener receiver problem
For the past 5 years, my Chamberlain Whisper Drive...
clarence_locke
Good material to patch potholes in old garage floor?
I have some pot holes in my 1963 garage floor. The...
griz8312
Sponsored Products
American Standard Jetted Bathtubs Gelcoat 4.33 ft. Walk-In Whirlpool and Air
Home Depot
Red 'Open' LED Wall Décor
$79.99 | zulily
American Drew Cherry Grove Corner China Cabinet - ADL4555
Hayneedle
Homelegance Grisoni Trestle Dining Table in Two-Tone Finish
Beyond Stores
Tommy Bahama Rolling Party Cooler
$299.00 | FRONTGATE
Upton Home Glynn 60-inch TV/ Media Stand
Overstock.com
© 2015 Houzz Inc. Houzz® The new way to design your home™