1/2 HP Craftsman garage door opener photo eye reversing

gnip187March 28, 2011

I recently put in a new main gear in my Craftsman 1/2 HP garage door opener. After putting everything back together, the garage door opens and closes fine, and will stop and reverse if it hits something on the way down.

My problem is with the photo eye's. When the laser is tripped, the door tries to close instead of opening. I've checked and double checked the wiring, but can't find anything. Any ideas?

Thank you for reporting this comment. Undo
don_1_2006

See if this helps. This should get everything back into proper sequence.

Loosen the chain enough so that you can remove it from the sprocket above the motor unit. With the door closed run the motor until the sprocket turns clockwise and stops. With everything attached replace and tighten the chain. Some adjusting of the up and down limits will probably be required.

    Bookmark   March 29, 2011 at 9:45AM
Sign Up to comment
More Discussions
Craftsman Garage Opener Clicks only and LED blinking 5 times
My 1/2 HP Model 139.53641SRT opener clicks to all my...
nosleep
Wayne Dalton i-Drive vs. Belt Drive vs. Screw Drive
Hello All, I am looking to install 2 new garage door...
rogeroh
Unfinished Detached Carport from 1924
Hi, My house and an accompanying detached garage were...
Central_Cali369
Garage Door Torsion Spring
Have you noticed that local HomeDepot/Lowes do not...
mister_h
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™