Craftsman Garage Door Opener

JMBDMarch 19, 2011

I thought I had posted this message yesterday but now I can't find it anywhere so I assume I didn't do it right. Here goes again. I have a 1/2 HP Craftsman Opener that was installed by the previous owner when my house was built in 1985. He didn't leave me an owner's manual and I can't find a model number anywhere on the unit. Two days ago it stopped responding to the remote. It works fine with the hard-wired wall unit. I got a new remote, transferred the code switch settings from the old remote, verified them with the unit itself - still no response. So, I assume the problem is with the receiving module on the unit. I can't get anywhere with Sears without a model number. Any suggestions?

Thank you for reporting this comment. Undo
don_1_2006

If the wall unit has 3 buttons and the light in it is flashing, press and hold the lock button for 3 seconds. If this is not the case your receiver has quit. It is part of the logic board. You would be better off with a new opener at this point.

    Bookmark   March 21, 2011 at 4:25PM
Sign Up to comment
More Discussions
Garage door won't open - even manually
Our garage door won�t open - the motor works,...
karyn
Unfinished Detached Carport from 1924
Hi, My house and an accompanying detached garage were...
Central_Cali369
Need Help with My SnowBlower
I just recently bought a Craftsman 24" snow thrower,...
bdouble
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
Turning part of garage into storage/man cave/laundry
Some background in my project: 1. I need a study, so...
toffee-el
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™