Genie Pro 88 Opens but Does Not Close!

teatacMarch 13, 2007

My Genie Pro 88 is about 18 years old.

Suddenly it seems to only open. To close it, I must pull the emergency handle to disconnect it, then close manually.

However, if I reconnect the mechanism once the door is closed, it opens just fine.

If the door is in the open position and I activate the button (either hard wired or remote), absolutely nothing happens. The motor just doesn't come on.

Anyone have any ideas?

Thank you for reporting this comment. Undo
doorguy06

Bad circuit board and it is not available anymore. I would replace it with a craftsman or liftmaster belt of chain drive.

    Bookmark   March 16, 2007 at 3:52PM
Sign Up to comment
More Discussions
Wayne Dalton i-Drive vs. Belt Drive vs. Screw Drive
Hello All, I am looking to install 2 new garage door...
rogeroh
Custom Wood Garage Doors
Does anyone know or have experience with wood garage...
linda_1010
Need error codes for Craftsman 41A4315-7D.
Need error codes for Craftsman 41A4315-7D Garage Door...
don831
Sears GDO does not close
I've searched on the forum without any luck. My Sears...
jerseybob_gw
Unfinished Detached Carport from 1924
Hi, My house and an accompanying detached garage were...
Central_Cali369
Sponsored Products
Abbyson Living Charleston Solid Wood 72-inch TV Console
Overstock.com
36" Matthews Duplo Dinamico Bronze Wood Ceiling Fan
Lamps Plus
Tech Lighting | K-Corum Kable Lite Fixture
$223.20 | YLighting
Ubabub | Nifty Change Table
YLiving.com
Rockford Harbor Gray Shaker Kitchen Cabinet Sample
CliqStudios Cabinets
Coral Wool Rug - Brown/Cream - Thomas Paul
$351.00 | HORNE
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™