Craftsman Garage Door Opener

texashondaFebruary 1, 2010

My door opener went completely dead and would not supply power to the lights. I check outlet for power and had 120V. I thought the logic board was fried, so I bought a used motor module off ebay (cheaper than a replacement logic board). I removed defective unit and replaced w/ used unit w/o problems. Unit now works fine.

I decided to check my removed motor module by plugging into power and shorting the manual switch to see what would happen. It came on (LED flashed code 1) and when switch was shorted ran a few seconds and went off. Motor stuttered and LED flashed code 4 when I shorted again to see if motor would reverse.

Is it possible, the logic board is OK? Can I test the logic board w/o the saftey sensors attached to logic board? I will keep removed motor module for spare parts, but I have sneaky suspicion that it's OK.

thanks

Thank you for reporting this comment. Undo
don_1_2006

You can't test the logic board beyond what you are doing without the sensors attached. I would pull the logic board and check for burnt or missing traces on the printed circuit especially around the small transformer. The connections to the transformer sometimes come loose.

    Bookmark   February 2, 2010 at 9:32AM
Sign Up to comment
More Discussions
Allister GDO not closing with remote
Having a problem with my Allister Access 3500 GDO not...
irishh7
Craftsman Garage door openers old dipswitch technology
My garage door motors still work great- 30 years old....
mamasalvo
New construction.. Trying to decide on what flooring for garage..
Ok.. So we are building a brand new house and one of...
Jason143NBPD
Snowblower help
I have a M t d model 317e760f118 track driven snow...
thechad1985
Turning part of garage into storage/man cave/laundry
Some background in my project: 1. I need a study, so...
toffee-el
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™