Garage Door wont travel full distance

tomnohioJanuary 31, 2010

Craftsman 1/2hp 13953657SRT

Replaced gear assembly due to wear and tear and malfunction, gears worn completely off.

Everything appears to be re-assembled correctly but travel of unit is 8" down and 8" back up, without door attached.

Safety sensors are green and remain green through cyle.

Downward and upward limits are not even coming in contact with the unit sensor. The force settings seem to have no effect on travel. I have adjusted chain to see if it would affect and no luck seems to be fine, no binding or sag.

Could this be the motor?

Looking for any help possible.

Thank you for reporting this comment. Undo
tomnohio

Read alot of post and tried most every possible correction, took it all apart and rebuilt it from scratch, working great not sure what the problem was, think it might have ben plug to the limits not securley attached.

This forum helped a great deal, thanks!

    Bookmark   January 31, 2010 at 2:40PM
Sign Up to comment
More Discussions
Need Help with My SnowBlower
I just recently bought a Craftsman 24" snow thrower,...
bdouble
Easy to use Backpack Blower Storage
I have been keeping my backpack blower on the floor...
blakeas
Garage Door Exterior Lighting Help Please
Hello members, On the exterior, do you prefer lighting...
pippit
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
Garage door won't open - even manually
Our garage door won�t open - the motor works,...
karyn
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™