Heat N Glo flame height

jscozzDecember 14, 2009

I have a Heat N Glo unit that I bought back in 2001 and finally had it installed a few years ago. I think it is a 5000TRV (rings a bell).... the flame is VERY low... looks terrible... and this is on the High setting. Only one of the 3 flame clusters actually clears the log opening (barely) and is visible above the log... the rest is just underneath. Does anyone know if there is any way to adjust the flame height? Mine is set-up to use the remote control, but I have also tried adjusting the valve manually (the off, on pilot marked valve). Gas supply is not an issue.

Any advice would be greatly appreciated.

Sign Up to comment
More Discussions
HeatnGlo Mezzo 48 or Napolean Linear LHD50
Please help guide me! We are building a new home and...
cleaning soot off rock fireplace surround
My rock wall fireplace looks dingy from 50 years of...
Travertine tile reface on fireplace surround & hearth
Help - We have torn down the old fake stone facing...
Feedback on MORSO 5660 unit with blower
Hi all- we're replacing our wood insert to get a sleeker...
help please ! saw a picture, how can this be made?
Can anyone help me figure out these dimensions and...
Sponsored Products
Chandra Rugs | Thomas Paul Toile Rugs
Tribeca Grand Chandelier by Michael McHale Designs
| Lumens
Silver Vertical Flat Panel Designer Radiator 63 x 14 & Valves
Hudson Reed
Red Porcelain Nonstick 1-Qt. Jumbo Butter Warmer
$14.99 | zulily
Seaside Brushed Steel Dark Sky Outdoor Wall Light
$67.00 | Bellacor
Hillsdale Northern Heights Non Swivel Counter Stool (Set of 2) in Black & Honey
Beyond Stores
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™