Have a question

hoerlelAugust 25, 2005

A co-worker of mine has a Brother PE150 and she said that she cannot adjust the tension in her bobbin because there is no case and the bobbin just sits down on a spindle. She does not have the manual. I find it hard to believe that a bobbin in any machine would not have a way to adjust the tension. Can you help?

Thank you for reporting this comment. Undo

I have a Pe150. Is she threading the bobbin correctly?
The directions for threading the bobbin are as follows.
1. Insert the bobbin into the shuttle following the thread direction as noted in the etching under the bobbin cove.
2. Guide the thread end around the finger through the channel toward the back. The channel is on the left hand side.
3. Close the bobbin cover by placing the left end in place and pressing down lightly on the right end to snap in place.
There is no need to pull up the lower thread, it is done automatically.
According to what I read in my manual all adjustments are made on the upper thread tension.
Tell her to contact brother for a manual.

    Bookmark   August 26, 2005 at 10:21AM
Sign Up to comment
More Discussions
hand embroidery needle HELP!!!
Hi! I need to find a specific type of embroidery needle:...
Brother 270D
Hi to all, I may be the new owner of a Brother 270D...
PE Design Software
I lost my PE design2 when I changed computers.I am...
Help with embroidery
I just recieved the Brothers SE400 sewing and embroidery...
pe design 2.0 help!!
hiya ive brought pe design 2.0 off of ebay its come...
© 2015 Houzz Inc. Houzz® The new way to design your home™