danby clothes dryer beeps after 2-5 minutes

ilmbgDecember 21, 2013

My Danby has always been great. Just as good as my expensive Asko. (Washer good except cannot spin heavier single items such as one bath towel, small bath rug).
What am I or the dryer doing wrong...? About 25-50% of the time the dryer beeps the 'I'm dry', beep after It is running but of course the clothes are not dry at all. I thought maybe I had to turn it off between loads and reset each load...nope, it still might beep. If I don't turn it off and put a new load in and hit start it might do it then also.
It is random. It has done this since I got it.
What am I doing wrong?

Thank you for reporting this comment. Undo

Chances are the moisture sensor is faulty. This is the thing that the dryer uses to determine the dryness of your clothes.

    Bookmark   December 22, 2013 at 10:25AM
Thank you for reporting this comment. Undo

Late return to thread...
It is nothing faulty. I just needed to turn the dial and stop at the top for 5 seconds, per dryer instructions, then continue to setting.

    Bookmark   May 9, 2014 at 7:52AM
Sign Up to comment
More Discussions
cancer warning on kitchenaid dw
New kitchenaid dishwasher manual has warnings for chemicals...
Wolf MDL error update
Wolf came out today and they are going to replace the...
Bertazzoni gas range comprehensive review
So I've seen this question presented a few times, and...
New Bertazzoni Induction Range?
I just saw a press release from Bertazzoni about a...
miele dishwasher gold substance explosion
i had a new water heater installed this morning and...
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™