silly question: shower head and tub drain location

M_N_ANovember 13, 2013

most of the time shower head and tub drain are on the same side. Is there a reason why?

When I wash my hair, I don't like the foam piling up on my feet. Also when the drain the water will flow longer and lesser chance to back up.

can I put them on opposite side? any issue there?

Thank you for reporting this comment. Undo

I don't know specifically, but there are many showers using the linear drains and they are on the back wall, away from the shower spout I believe. And when people have a 2 headed shower, they both can't be over the drain can they :) Take a look on houzz for drain locations and see what you find...I just did a search and I think you will be pleased at what you see. Check out the link.

Here is a link that might be useful: Houzz shower drain locations

    Bookmark   November 13, 2013 at 5:58PM
Thank you for reporting this comment. Undo

yes I have seen different variation but most often they are on the same side

i think i just guessed why. for shower pan it probably does not matter but for tub, if people don't want to lean on the tub spout, they would sit on the other side (i.e. sitting on the drain)

Is that why? I dont take bath so I wouldn't know:P

    Bookmark   November 13, 2013 at 6:59PM
Thank you for reporting this comment. Undo

It's mostly because it's the shortest amount of pipe and the necessity for only one plumbing wall when they are all mounted centered one over the other up the wall.

    Bookmark   November 13, 2013 at 8:42PM
Thank you for reporting this comment. Undo

oh ok i see. as long as there is no hidden issue, I would like to put them on different side. thanks!

    Bookmark   November 14, 2013 at 1:27AM
Thank you for reporting this comment. Undo

The only real thing that matters in my view is the slope to get the water out of the pan. The drain needs to be at the lowest point. You still want to be able to stand on the surface without risk of slipping into the lowest point. So the slope can't be too shallow or too steep.

If you want to put the drain someplace against the far wall I don't see why there could be an issue, except as Ieffablespace mentions, the efficiency and cost of plumbing more run. In my remodel all my joist were in place. I had to plan carefully were all drains and water sources entered into the room. There were a few places where I had less than an inch tolerance to one side. If I couldn't make it work one way I had to go back to the drawing board. I did my own layout plans. I knew all my dimensions of fixtures. I consulted my plumber often. It is a team effort.

    Bookmark   November 14, 2013 at 9:21AM
Sign Up to comment
More Discussions
Tub surround - replace or embrace?
We're remodeling our MB on a tight $5k. DIY'ing everything...
anyone know this brand for shower fixtures?
Trying to get a replacement part. Bathroom remodel...
Date on thinset
Someone mentioned they would help homeowners decode...
Kohler Elevance Tub - for disabled - gorgeous
Pretty new product from Kohler. anyone who is looking...
The towel ring and the towel bar
The last bit for my bathroom arrived today, a hand...
Sponsored Products
Chooty and Co Zoom Zoom Bella D-Fiber Pillow - CS17K3009
$36.99 | Hayneedle
Sakura Shower Curtain
$79.99 | Dot & Bo
Robert Abbey Ant Bee Swing Arm Pharmacy Floor Lamp
Lamps Plus
Coleen Elegance Goblet
$80.00 | Horchow
Louis Poulsen | AJ Floor Lamp
Vigo Stainless Steel Pull-out Spray Kitchen Faucet and Soap Dispenser
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™