wall tile pattern problem

rebawOctober 24, 2011

We have 8x10 white tiles and 47" width of wall. We were going to put them in a staggered position, but that would end up with just a one inch sliver every other row. Are there photos of tiles with an offset of 7" rather than at the middle 5" of the tile? I'm having a hard time explaining the problem. Can't find it on Bridge's tile website either. thanks.

Thank you for reporting this comment. Undo
weedyacres

Just shift your whole design over by 3". So if your original plan was:
odd rows: start with full tile, end with 6" tile
even rows: start with half tile, end with 1" tile

your new plan would be:
odd rows: start with 3" tile, end with 3" tile
even rows: start with 8" tile, end with 8" tile

    Bookmark   October 25, 2011 at 7:42PM
Thank you for reporting this comment. Undo
bill_vincent

Weedy-- we know you meant TWO inches. :-)

    Bookmark   October 25, 2011 at 9:21PM
Sign Up to comment
More Discussions
Showers 101
I'm hoping there is someone who can direct me to a...
jpbenstock
40" for double vanity, any suggestions?
Hi, We are remodeling our bathroom and would like a...
rickyk22
Cast Iron, Soaking, Free Standing Tub?
That is what I think I want, but I'm not finding very...
prairiemoon2 z6 MA
Shower drain installed off-center in subfloor - how to fix? Urgent...
Well back to the (new & improved?) Gardenweb. I...
AHMIowa_NJ
Tile install question
I've been posting a lot about our upcoming master bath...
numbersjunkie
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™