Turning Ductwork

saw50st8March 12, 2012

We are in middle of our new kitchen installation and have a ductwork problem.

We purchased this hood: http://www.ajmadison.com/cgi-bin/ajmadison/AK7036AS.html

Our original plan was to vent in the rear right to the outside. However, we didn't realize the duct would interfere with a new support beam placed at the wall.

Our two options are:

1) Instead of venting in the rear, have ductowrk from the top, turn 90 degrees and then turn 90 degrees again to the outside wall (hood is on the exterior wall)

2) Swap the rangetop with the next cabinet over. This would place the rangetop right next to our corner cabinet and would reduce the size of an upper cabinet on either side of the rangehood (instead of 1 full size cabinet).

The cabinets are almost complete so it would likely be an extra cost. Option 1 wouldn't cost us anything really.

Are two 90 degree bends in a short span ok?

Thank you for reporting this comment. Undo
Caddidaddy55

A 90 deg. bend is the eqivelent of 5 feet of straight pipe, so it should be no problem.

    Bookmark   March 12, 2012 at 12:54PM
Sign Up to comment
More Discussions
Fisher Paykel Dishwasher Drawers-do you have them?
I am in need of guidance. From what I can gather, it's...
beekeeperswife
Why are my frozen bananas melting?
Not sure the right forum for this, but I freeze bananas...
weedyacres
Help Me Choose A Wall Oven
I have a Gaggenau 24" inch convection oven over...
heron3
HELP PLEASE New Dacor range to replace old DCS (Fisher Paykel) range?
We moved into a house that has a 9 year old DCS by...
princesspronoid
High end appliances thermador vs. dacor
I currently have dacor ovens. I am trying decide brands...
mcaprizs
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™