Tip on using vinyl cornerbead

andrelaplume2March 16, 2012

Is the trick to use more or fewer screws...I having issues keeping the product from bubbling in some areas. Do you drive the screws a little below the surface???

Thank you for reporting this comment. Undo

well, no help on the vinyl stuff...I was thinking of using metal then...though vinyl would seam better in basement. Same question though...how far apart do the screws/nails go and how far do you drive them in....I think I drove them in too far on the vinyl...caused bubbling...but it still does not hug the corner in spots...I know there must be a trick...only ever did one corner before...came out ok but do not recall how many screws I used...

    Bookmark   March 20, 2012 at 4:35PM
Sign Up to comment
More Discussions
What to do with old cistern room?
The house I'm buying has a weird feature. There's a...
Mysterious Concrete Box in Basement
I am considering placing an offer on a house (built...
Spray foam basement band joists
I just had an energy audit and one thing they recommended...
Which drywall to use in the basement?
Hi, I am finishing a basement that is under the attached...
Basement wall insulation
Hello, I live in a 1952 English bungalow in Chicago...
Sponsored Products
Minka Westgate 13" High Bronze Outdoor Wall Sconce
$79.90 | Lamps Plus
Reign Concealed Thermostatic Triple Shower Valve & Diverter 3 Outlets
Hudson Reed
Cream red striped antico due linen napkins (set of four)
Origin Crafts
Premium Furniture/Cabinet Polish - 16 oz.
Signature Hardware
Ocean Wave Outdoor Area Rug
$495.00 | FRONTGATE
Oxygen Lighting | Alpha Wall Sconce
$111.00 | YLighting
Basketweave Plynyl Floor Mat by Chilewich
$125.00 | Lumens
Foscarini | Havana Floor Lamp
© 2015 Houzz Inc. Houzz® The new way to design your home™